What are the steps in the production process of gypsum powder production line

Simply put, the gypsum powder production line is the equipment that produces accurate suspended ceilings throughout its life. The manufacturer of the automatic production line for stone slabs has a complete production process, which is composed of specialized equipment such as raw material supply system and board making system. The gypsum powder production line has lower prices and is capable of producing high profit products. It can recover costs in the short term, does not pollute the environment, and can recycle waste to achieve the desired effect. Our production line combines the advantages of similar equipment and solves the shortcomings of traditional gypsum board automatic production lines, such as low strength and poor working performance. And the core components are very high-quality, with the advantages of excellent quality and small footprint. The finished product has good flatness, small difference, and is resistant to deformation. At the same time, mechanical equipment can produce products of different specifications, and the automatic production line of Shiyu board is convenient for maintenance in case of malfunctions.
The gypsum powder production line adopts hydraulic molds during production, which can reduce the resistance of silicon oxide materials by pressing, thereby reducing the failure rate of the formed board. After the material is prepared, it enters the hydraulic pulp crusher and is mixed into the original slurry for later use. The foaming agent and water are evenly mixed in a certain proportion, and the coagulant and gypsum powder raw materials are lifted and transported to the conveying system equipment before entering the silo.
In the past, manual processing of gypsum boards was relatively complex. Since the introduction of gypsum powder production equipment, the production process has gradually simplified, mainly divided into the following steps. Let's take a look together.
1. At first, operators should prepare materials, including gypsum powder, starch, accelerator, retarder, and cement. Then, these materials should be transported to the mixer of the equipment through pipelines or pumps. After setting the time, the gypsum board equipment will mix them in stages until they are mixed into gypsum slurry.
2. Afterwards, the gypsum slurry will flow along the equipment to the platform, and then undergo steps such as stirring, drying, heating, and solidification to gradually form a gypsum board. The molding equipment can meet the cutting requirements on the solidification belt. The gypsum board mechanical equipment manufacturer recommends that operators be careful when cutting.
3. The successfully cut product then passes through the drying zone and is heated, dried, and shaped using the hot air on the gypsum board equipment, and the product is considered completed.